Stokta Yok
Elnec
DIL24/QSOP24 ZIF 150mil Adaptör Soketi
Fiyat
:
0,00 USD + KDV
Stokta Yok
Stoklara düşünce haber ver
- Ürün Özellikleri
- Ödeme Seçenekleri
- Yorumlar (0)
- Tavsiye Et
- Resimler
-
DIL24/QSOP24 ZIF 150mil Adaptör Soketi
- universal adapter, assigned for QSOP devices up to 24 pins (for example Holtek HT46, HT48 series, Cypress CY7Cxxxxx series, Sonix SN8P22000, SNP25000, SNP26000, SNP27000 series)
- operation (mechanical) life of ZIF socket - 10.000 actuations
- made in Slovakia
Ord. no. 70-0391 Socket ZIF QSOP24, open top type Bottom 2 rows, 2x 12 pins, square, 0.6x0.6mm, rows spacing 600mil Class Universal Subclass DIL/(T)SSOP Adapter manual
- Insert adapter to the device programmer ZIF socket according to the picture placed near of it. If you have some doubts about orientation of this adapter in device programmer ZIF socket, it is valid general rule, the orientation of the text of title is the same as the text on the top of the device programmer.
- Push the top of adapter ZIF socket to open it. Insert the device into the adapter ZIF socket. The right position of the programmed device in adapter ZIF socket is show at picture near (mainly left above) the adapter ZIF socket. Then release adapter ZIF socket. If you use this adapter for devices with less than 24 pins, then place device to the bottom edge of adapter ZIF socket. Upper contacts stay unconnected.
- Visually check interconnection between device and adapter ZIF socket. If everything looks OK, the device is ready for programming.
- Be careful, because the incorrect insertion of adapter to the device programmer ZIF socket or device to the adapter ZIF socket can damage the programmed device.
- To take out the device push the top of adapter ZIF socket and remove device from it.
- When you finish work with adapter, remove it from the device programmer ZIF socket.
- Do not directly touch the pins of the adapter and adapter ZIF socket, because dirt may cause errors during programming of device.
- For handling with the device we recommended to use a vacuum pick up tool.
- Operation conditions: operating temperature 5°C ÷ 40°C (41°F ÷ 104°F), operating humidity 20%..80%, non condensing.
- If programming yields isn't 100% when using programming adapter or if some unreliability appears, try to connect one 22nF-100nF multilayer capacitor (that meet the EIA X7R or Z5U specification) between leads of adapter connected to pins VCC and GND pins of programmed chip.
Accepted package(s)
QSOP24 
Benzer Ürünler
